Daktronics Outdoor LED Scoreboards Service Manual Manuel d'utilisateur télécharger pdf (Page 32)

26 TNMC & Electronic Caption Troubleshooting & Maintenance

To replace a module from the rear:

1. Follow the steps in the Rear Access method described in Section 3.5.

2. Use a 1/8" hex wrench to loosen the latch fastener assembly (Figure 26). Turn each

fastener a quarter-turn.

Note: Do not over turn the fastener!

3. While holding onto the module, push it out and turn it in such a manner (generally a

sideways, diagonal turn) that it can be pulled back through the frame opening.

4. Carefully disconnect all power and signal cables. It may be helpful to label the cables

to know which cable goes to which connector when reattaching.

5. Reconnect all power and signal cables to the new module and push it back through

and out the front of the display frame.

6. Re-latch the fasteners.

7. Power up and test the scoreboard/display to see if the problem has been resolved.

Weather-stripping

To ensure that the display is waterproof, weather-stripping has been installed around each

module. It is important that the weather-stripping is attached properly at all times, or water

may leak into the display and damage the components.

When installing a new module, take note of the following points:

 The weather-stripping on the back edge of the module must be intact and in good

condition to prevent water from seeping into the display.

 The module latches must be fully engaged to create a watertight seal around the edge

of the module. The module should be firmly seated against the display when the

latches are fully engaged.

Figure 26: Module, Rear View

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 51 52

Pas de commentaire

Daktronics Outdoor LED Scoreboards Service Manual Manuel d'utilisateur Page 32