Daktronics OmniSport 2000 Timing Console Manuel d'utilisateur télécharger pdf (Page 86)

68 OmniSport 2000 Pro Swimming Software

Serial Port Setup

1. Ensure a straight-through 9-pin male to 9-pin female serial cable is connected

between the computer’s serial port and the J4 EXPANSION PORT on the OmniSport

2000 timer (a USB-to-serial adapter may also be required).

2. Power on the console, set the name, date, and time, and then select 1-SWIMMING.

3. Start the Pro Swimming software (see Section 6.3).

4. Go to Options > Configure and click on the Comm Ports tab (Figure 70).

5. Click Configure in the Interface Comm Port area.

6. In the window that appears (Figure 72), select COM Port as the Type.

7. Click on the Com Settings tab (Figure 73). Select an available COM Port, set the Baud

to 38400, and then click Apply followed by Finish.

8. Back in the Interface Comm Port area, click Monitor (Figure 93).

 If the computer is receiving data in the top half of the monitor window, the

connection was made properly and the correct communication settings are

configured. Data on the bottom half is being sent by the Pro Swimming software.

 If the computer is not receiving data, go back to step 7 and select a different port.

Do this until data is received through the selected port.

Figure 72: General Setup

Figure 73: Com Settings

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 115 116

Pas de commentaire

Daktronics OmniSport 2000 Timing Console Manuel d'utilisateur Page 86