Daktronics DMP-1500/M3 (SS & ST) Setup With Show Control Manuel d'utilisateur télécharger pdf (Page 8)

DMP-1500/M3 (SS & ST) Setup With Show Control Quick Guide 8 of 11

201 Daktronics Drive PO Box 5128, Brookings, SD 57006

Tel: 1-800-325-8766 or 605-697-4300 Fax: 605-697-4746

Website: www.daktronics.com

DD1805670 Rev 11

2 July 2012

1. Insert the Daktronics Communication Server (DCS) installation CD

(Daktronics part number 0A-1453-0035) into the CD-ROM drive

(typically “D:\”).

2. Press the Windows key [] + [E]. Double-click your CD-ROM drive,

and then double-click the “dcs3” file.

3. Follow the onscreen instructions to complete the installation.

4. Once the installation is complete, double-click the

shortcut icon on the desktop to run the program.

An icon will also appear in the taskbar.

Note: After the initial installation, each time the computer is started,

DCS should begin running automatically (visible in the taskbar).

5. Click the Ports button on the left-hand side of the window:

6. Double-click Port 5. The Port Configuration window will open.

Configure Port 5 as follows:

 Name: must be “Output”

 Type: UDP/IP Socket

 Port: “3002”

 Click Advanced>> and set the Mode to Transmit only.

 Leave all other settings as is; click OK when finished.

7. Double-click Port 2. The Port Configuration window will open

again. Configure Port 2 as follows:

 Name: “Hy-tek” or another descriptive name

 Type: Serial Port

 Port: COM1* (may vary depending on the exact COM port

available on the computer)

 Baud: 19200

 Leave all other settings as is; click OK when finished.

DCS Installation (Track Timing)

The Daktronics Communication Server (DCS) is typically only required when displaying Real Time Data (RTD) for track events.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Pas de commentaire

Daktronics DMP-1500/M3 (SS & ST) Setup With Show Control Manuel d'utilisateur Page 8